STIM210 MEMS GYROSCOPE
3 AXES MEMS GYROSCOPE MODULE
Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM210 may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.
ADVANTAGES
-
Shock & Vibration Resistant
-
Reliability and Robustness
-
Multi-Application Support
REQUEST A QUOTE
FEATURES
- 1, 2 or 3 axes offered in same package
- RS422 interface
- Excellent environmental robustness
- Low bias drift
- 5 different bandwidths available
- Selectable output unit: angular rate [deg/s] or incremental angle [deg]
- Miniature package
- ITAR free
- 24 bits resolution
- Low noise
- LP filter -3dB frequency can be set individually for each axis
- Continuous self-diagnostics
- Excellent performance in vibration and shock
- Electronically calibrated axis alignment
- Single-crystal silicon technology
- 5 different sampling rates available
- RS422 protocol, bit rate and line termination
SPECS
- Power Supply: 5.0 V
- Operating Power Consumption: 1.2 W
- Operating Temperature: -40°C to +85°C
- RS422 Protocol
- Start Bit: 1 bit
- Data Length: 8 bits
- Parity: None
- Stop Bits: 1 bit
- Timing
- Startup time after power-on: 0.3 s
- Time to transmit after reset: 0.2 s
- Time to valid data: 0.7 s
STIM210
IMUs and Gyroscopes
